This Woodcraft clutch cover protector is beautifully machined and easy to install. With the stainless steel insert, this cover should provide good protection to the Tuono's vulnerable clutch case. After installation I noticed a gap of about 1mm between the rubber pad on the inside of the Woodcraft part and the Tuono's clutch case. Either the pad is too thin or the four spacers under the clutch cover protector are too long. I fabricated a gap-filler for the space and re-installed the Woodcraft part. I was concerned that if the bike ever did touch down on its right side, the gap might allow the Woodcraft cover to pry the bottom case fasteners out of their threaded holes.