Fitment Information:
- The Driven DBEW-ADP-FZ bar end apapter kit is designed for use with Driven Bar Ends and Driven Bar End Mirrors when the supplied hardware for either will not allow for installation on your motorcycle.
- Adapter to fit Yamaha FZ models where the bars are shorter than the grip. DBEW-ADP-FZ (Set of two) Finish: Raw
- We recommend you remove your stock bar ends and inspect the bar ID and design before ordering if you are unsure of what you need to complete the install. As always Team STG is available to answer any question.
Instructions & Exploded ViewWrite Review
-
Required for MT-09 2019-21
These adapters are required for the MT-09 2019-21 as well as the FZ-09. Also note, the Driven bar end mirrors come with wedges to fit in hollow bars. The wedges have bolts threaded only 1/2 way, so will not actually work with the mirrors and these adapters. You will have to get replacement bolts. I was able to use 1.5" 6mm (fully threaded) hex bolt sourced from my local hardware store.
-
Unfortunately they don't fit
Ordered per the recommendation that they fit yamaha r6 unfortunately they don't fit the 03 so I'm stuck with them as the cost of return shipping would be about the same as I paid for them. That leaves me with bad ends and adaptors i can't use. Driven you dissapointed i have to look at other options and trash the adaptors and bar ends I wasted the money on
-
Thread issue
Thread figment caused an issue when installing but a little grease and hard turning worked out. Other side worked fine. May have been bar threads.
- Availability:
- STG Part Number:
- D|1405-DBEW-ADP-FZ|0
- Manufacturer's Part Number:
- 2
