GB Racing Yamaha YZF-R1 15-22 Engine Cover Set

1. CRASH TESTED

2

Posted by Unknown on 27th Jul 2016

Cosmetic wise these "covers" add an overall good look to the bike. When I was putting them on I felt that these were no more than just hardened plastic and was very skeptical on how well they would hold up in the event of a low side. Well 2 weeks after install I got to find out how well they hold up from a low side at about 30mph and the cover did absolutely nothing. The case cover ground right through like it wasn't even there causing the stator cover needing to be replaced. These covers are not worth the money, for $30 more you should just get the woodcraft case savers that actually work.

2. Great added protection and design

5

Posted by Unknown on 28th Aug 2015

The product quality was great. I actually had mine powder coated, holds paint very well, looks great. The set comes with straight forward instructions and an overall great buy

3. Case guards

5

Posted by Unknown on 25th Aug 2015

Haven't been tested yet,don't want to. The case guards were easy to install. They look great.

4. Great investment for any bike

5

Posted by Unknown on 23rd Jun 2015

Installed these on a 2015 R1M, Almost no troubles. The alternator cover required me to take off the side panel to install, no big deal when doing routine maintenance. When installing the pulse cover, taking all but one bolt out did produce a small oil leak until new bolts and cover went on. Not sure if it was just because the bike was warm or not (just finished an oil change) but something to watch for. Everything installed looks great, fits great, and I hope that I do not have to test how well they handle an impact.

5. QUICK AND EASY

5

Posted by jim on 26th May 2015

The case covers were reasonably priced, quick to install and excellent fit and finish.

6. Nice

4

Posted by Unknown on 18th May 2015

I've bought these for two different bikes. It saved the engine cover during a low side, so they are worth the money.

7. Great protection for 2015 R1

4

Posted by Unknown on 2nd May 2015

The installation on these covers was very straight forward and the fit looks factory. The covers feel high quality, but I hope I never need to test their crash worthiness. One word of caution...it seems that the pulse cover requires all but one factory fastener to be removed...be gentle or you may have a little oil drip out. I had about a quarter sized amount drip onto the ground while the fasteners were removed, however, when I installed the pulse cover and screws, the leak went away. Ran the bike, no leaks.